Installation Procedure
- Remove the plug from the rear brake caliper inlet.
Rear Brake Hose (3) - Install
Brake Hose Fitting Gasket (2) @ Brake Hose Fitting (3) - Install NEW [2x]
- Brake Hose Fitting Bolt (1) - Install and tighten 44 N.m (32 lb ft)
Brake HoseBracket Nut (1) - Install and tighten 9 N.m (80 lb in)
- Remove the plug from the rear brake hose outlet.
Brake Pipe Fitting (1) - Install and tighten 18 N.m (13 lb ft)
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Bleed the brake system. Hydraulic Brake System Bleeding (Manual without JEO) , or Hydraulic Brake System Bleeding (Pressure without JEO) , or Hydraulic Brake System Bleeding (Pressure with JEO)
- Install the tire and wheel assembly. Tire and Wheel Removal and Installation
- Remove the support and lower the vehicle.
CAUTION: