LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2023 >> Acadia SLE, FWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Diagnostic Information and Procedures >> DTC C058A, C058E, or C0594-C0596 >> Circuit/System Verification

Circuit/System Verification

  1. Ignition - On/Vehicle - In Service Mode
  2. Perform the scan tool configuration/reset function: Brake System Plunger Motor Position Sensor Learn
  3. Clear DTCs
  4. Verify DTC is not set:
    • If the DTC is set 

      Test or replace the component: A104 Brake Master Cylinder

    • Go to next step: If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals