Fuel Tank Filler Pipe Housing Replacement
 Courtesy of GENERAL MOTORS COMPANY
|
NOTE:
Callouts items in the following chart represent components shown in graphic above.
| Callout |
Component Name |
Preliminary Procedure
Fuel Tank Filler Door Replacement . |
| 1 |
Fuel Tank Filler Pipe Housing Retainer [4x] Procedure
- Using a flat-bladed tool that fits into the 4 depressions, break through the 4 depressions with light pressure and then pry the clips free to release the fuel tank filler pipe housing from the body side outer panel.
- The fuel tank filler pipe housing once removed cannot be reused and must be replaced with a NEW fuel tank filler pipe housing.
|
| 2 |
Fuel Tank Filler Pipe Housing Procedure
- Disconnect the electrical connector.
- Position the fuel tank filler pipe housing to the body side outer panel and the fuel filler pipe.
- Press the fuel tank filler pipe housing to the body side outer panel until fully seated.
- Ensure the fuel tank filler pipe housing seal is full seated to the filler pipe.
|