Component Testing
- Ignition/Vehicle - Off
- Remove the component:Transmission Cover
- Disconnect the electrical connector:X1 @ T12 Automatic Transmission Assembly
- Test for 45 to 44000 ohms between the test points:Signal terminal 23 & Low Reference terminal 22
- If not between 40 and 45000 ohms
Replace the component:B13 Transmission Fluid Temperature Sensor
- Go to next step: If between 40 and 45000 ohms
- If not between 40 and 45000 ohms
- Verify the value is within the range listed in the table:Refer to:Temperature Versus Resistance (B13 Transmission Fluid Temperature Sensor)
- If not in the specified range
Replace the component:B13 Transmission Fluid Temperature Sensor
- Go to next step: If in the specified range
- If not in the specified range
- All OK.