Component Testing
- Remove the component:Control Valve Body Cover
- Disconnect the appropriate electrical connector:Q77 Transmission Control Solenoid Valve
- Test the resistance between the test points:Terminal 1 @ Q77 Transmission Control Solenoid Valve & Terminal 2 @ Q77 Transmission Control Solenoid Valve
Verify the value is within the range listed in the table:Transmission Solenoid Information
- If not in the specified range
Replace the component:Q77 Transmission Control Solenoid Valve
- Go to next step: If in the specified range
- If not in the specified range
- Test for infinite resistance between the test points:Terminal 1 @ Q77 Transmission Control Solenoid Valve & Ground
- If less than infinite resistance
Replace the component:Q77 Transmission Control Solenoid Valve
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.