Circuit/System Verification
WARNING: This page is about a different car, the 2022 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Perform the following action:Range Selector Lever Cable Adjustment
- Operate the component:S3 Transmission Shift Lever - Select each position
Verify the scan tool parameter:Internal Mode Switch A/B/C/P @ K71 Transmission Control Module=The switch states match the values given in the table. - Refer to: Transmission Internal Mode Switch Logic
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- If not the specified state
- Operate the component:S3 Transmission Shift Lever - Select each position
- { R, D, M }Verify the scan tool parameter:Park/Neutral Position Switch @ K20 Engine Control Module=In Gear
- { P, N }Verify the scan tool parameter:Park/Neutral Position Switch @ K20 Engine Control Module=Park/Neutral
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.