Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
Wiring Harness Retainer (1) @ Rear Brake Hose - Remove [3x]
- Wiring Harness (2) - Position aside
Rear Brake Rear Pipe Nut (2) - Remove
- Rear Brake Hose Clip Bolt (3) - Remove
- Rear Brake Hose Bracket Bolt (1) - Remove [2x]
- Cap the front brake pipe outlet to prevent brake fluid loss and contamination.
Rear Brake Hose Fitting (2) - Remove
- Rear Brake Washer (3) - Remove and DISCARD [2x]
- Rear Brake Hose (1) @ Rear Brake Caliper - Remove
- Plug the front brake caliper inlet to prevent brake fluid loss and contamination.
Rear Brake Hose (1) - Remove