Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
High Voltage Battery Tray Reinforcement Nut (1) - Remove [4x]
- High Voltage Battery Tray Reinforcement Bolt (2) - Remove [2x]
High Voltage Battery Tray Reinforcement Bolt (1) - Remove [21x]
With the aid of an assistant, remove the high voltage battery tray lower front reinforcement (1).
Rear Brake Rear Pipe Nut (1) - Remove
Brake Pedal Push Rod Bolt (1) - Remove
- Brake Pedal Nut (2) - Remove [4x]
Turn the 3 front compartment sight shield retainers (1) a quarter turn counter clockwise to release.
Front Compartment Side Sight Shield (1) - Remove
- Thoroughly clean the brake master cylinder reservoir and the brake master cylinder body to remove any dirt and debris.
- Electrical Connector @ Brake System Control Module - Disconnect
- Electrical Connector @ Brake Fluid Level Indicator Switch - Disconnect
- Place a drain pan under the vehicle.
Remove the 4 rear brake front pipe nuts (1) and position the brake pipes aside.
Brake Master Cylinder Adapter Nut (1) - Remove
Maneuver the brake master cylinder (1) out of the vehicle.
- Brake Master Cylinder Gasket (2) - Remove and DISCARD
- Clean any brake fluid from the underbody area and remove the drain pan from under the vehicle.
Front Brake Front Pipe Clip (1) - Disengage [2x]
- Maneuver the right front brake pipe (2) out of the vehicle.