Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of fasteners may vary based on option content.

Hood Front Molding Nut (1) - Remove [2x]
Using a flat-bladed plastic trim tool, release the retaining clips.
Hood Front Molding (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connector.
Front Decorative Lamp Nut (1) - Remove [8x]
Courtesy of GENERAL MOTORS COMPANY

Front Decorative Lamp Bolt (1) - Remove [4x]
Courtesy of GENERAL MOTORS COMPANY

Front Decorative Lamp (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using the appropriate tool, release the integral retainers.
Hood Front Weatherstrip (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Front Bumper (1) - Remove [6x]
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connectors.
Wiring Harness Retainer (1) - Remove [5x]
Underhood Lamp Wiring Harness (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Center Molding Nut (1) - Remove [14x]
Courtesy of GENERAL MOTORS COMPANY

Hood Center Molding (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Hinge Nut (1) - Remove [4x]
With the aid of an assistant, remove the hood. (2)