Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Trim Finish Compartment (2) - Remove - Front Trim Finish Compartment Replacement
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- Left side shown, right side similar.
- Use a flat bladed plastic trim tool.
Front Fender Ornamentation Vent Bolt - Left Side and Right Side (2) - Remove [2x]
Release the retainers.
Front Fender Ornamentation Vent- Left Side and Right Side (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Using the appropriate trim tool, remove the windshield wiper arm finish caps (1) from the windshield wiper arms (3).
Windshield Wiper Arm Nut (2) - Remove [3x]
Using the appropriate tool, remove the windshield wiper arms (3).
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel Retainer (1) - Remove [4x]
Air Inlet Grille Panel (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front End Sheet Metal Cross Panel Bolt (1) - Remove [4x]
Front End Sheet Metal Cross Brace (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Duct Nut (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Duct (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Dash Panel Outer Insulator Retainer (1) - Remove [4x]
Heater and Blower Module Bolt (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Dash Panel Outer Insulator Retainer (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Dash Panel Outer Insulator (1) - Remove