Installation Procedure
Driver Monitoring Camera (1) - Install
Clip the instrument panel steering column upper trim cover (1) to the instrument panel carrier.
- NOTE:
Some components not shown for graphic clarity.
Connect the electrical connector. (1)
Secure the instrument panel steering column upper trim cover (1) to the instrument panel steering column lower trim cover.
- Return the steering column to its original position.
Connect the electrical connectors.
- Instrument Panel Trim Pad - Right Side (1) - Install
- CAUTION:
Refer to Fastener Caution .
Instrument Panel Trim Pad Bolt (1) - Install and tighten [8x] - Fastener Specifications
Instrument Panel Trim Plate (2) - Install
- Instrument Panel Trim Plate Bolt (1) - Install and tighten [2x] - Fastener Specifications
Instrument Panel Air Outlet Bezel (1) - Install
Instrument Panel Outer Air Outlet Bolt (1) - Install and tighten [4x] Front End Upper Tie Bar Bolt Fastener Specifications
- NOTE:
Left side shown, right side similar.
Radio Front Speaker Grille- Right Side (2) - Install
- Secure the retaining tabs.
- Radio Front Speaker Grille Bolt (1) - Install and tighten - Fastener Specifications
Connect the electrical connectors.
- Radio Control (1) - Install
Radio Control Bolt (1) - Install and tighten [2x] - Fastener Specifications
Radio Control Bolt (1) - Install and tighten [2x] - Fastener Specifications
Instrument Panel Upper Trim Panel Cover (1) - Install
- Secure the retaining tabs.
Instrument Panel Bolt Cover (1) - Install [2x]
- Secure the retaining tab.
Instrument Panel Lower Trim Panel (2) - Install
- Instrument Panel Lower Trim Panel Bolt (1) - Install and tighten [6x] - Fastener Specifications
Instrument Panel Trim Pad - Left Side (2) - Install
- Instrument Panel Trim Pad Bolt (1) - Install and tighten [3x] - Fastener Specifications
Instrument Panel Air Outlet Bezel (1) - Install
Instrument Panel Outer Air Outlet Bolt (1) - Install and tighten [4x] - Fastener Specifications
Connect the electrical connectors.
- Instrument Panel Knee Bolster (1) - Install
Instrument Panel Knee Bolster Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Instrument Panel Fuse Block Access Hole Cover (1) - Install
Radio Front Speaker Grille- Left Side (2) - Install
- Secure the retaining tabs.
- Radio Front Speaker Grille Bolt (1) - Install and tighten - Fastener Specifications
Instrument Panel Compartment (1) - Install
Open the instrument panel compartment door.
- Instrument Panel Compartment Bolt (1) - Install and tighten [3x] - Fastener Specifications
Instrument Panel Compartment Bolt (1) - Install and tighten [5x] - Fastener Specifications
Front Floor Console (1) - Install
- Connect the electrical connectors to the front floor console (1).
Front Floor Console Retainer Bolt (2) - Install and tighten [5x] - Fastener Specifications
- Front Floor Console Bolt Access Hole Cover (1) - Install
Front Floor Console Lower Applique (1) - Install
Front Floor Console Extension Panel (1) - Install
Front Floor Console Retainer Bolt (2) - Install and tighten [5x] - Fastener Specifications
- Front Floor Console Bolt Access Hole Cover (1) - Install
Rear Floor Mat (1) - Install
Tire Air Compressor (2) - Install
- Tire Repair Sealer and Tire Air Compressor Retainer (1) - Install and hand tighten
Front Floor Console Lower Applique (1) - Install
Front Floor Console Extension Panel (1) - Install
Front Floor Console Extension Bolt (2) - Install and tighten - Fastener Specifications
- Front Floor Console Extension Panel Bolt Access Hole Cover (1) - Install
Install the left and right front floor mat (1).
- Return the seat to its original position.
Connect the electrical connector.
- Instrument Cluster (1) - Install
Instrument Cluster Bolt (1) - Install and tighten [4x] - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Extension (1) - Install
- NOTE:
Left side shown, right side similar.
Connect the electrical connector.
- Windshield Garnish Molding- Left Side and Right Side (1) - Install [2x]
- NOTE:
Left side shown, right side similar.
Windshield Pillar Assist Handle Bolt- Left Side and Right Side (2) - Install and tighten [4x] - Fastener Specifications
- Windshield Pillar Assist Handle Cover- Left Side and Right Side (1) - Install [4x]
- NOTE:
Left side shown, right side similar.
Body Hinge Pillar Garnish Molding- Left Side and Right Side (1) - Install [2x]
- Install the weatherstrip as necessary.
- NOTE:
Left side shown, right side similar.
Instrument Panel Outer Trim Cover- Left Side and Right Side (1) - Install [2x]