Removal Procedure
Remove the left and right front floor mat (1).
- NOTE:
Use a flat bladed plastic trim tool.
Front Floor Console Extension Panel Bolt Access Hole Cover (1) - Remove
- Front Floor Console Extension Bolt (2) - Remove
Move the front seat to access the retainers.
- Front Floor Console Extension Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Lower Applique (1) - Remove
Tire Repair Sealer and Tire Air Compressor Retainer (1) - Remove
- Tire Air Compressor (2) - Remove
Rear Floor Mat (1) - Remove
Move the front seat to access the retainers.
- Front Floor Console Bolt Access Hole Cover (1) - Remove
- Front Floor Console Retainer Bolt (2) - Remove [5x]
- NOTE:
Use a flat bladed plastic trim tool.
Move the front seat to access the retainers.
- Front Floor Console Extension Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Lower Applique (1) - Remove
Move the front seat to access the retainers.
- Front Floor Console Bolt Access Hole Cover (1) - Remove
- Front Floor Console Retainer Bolt (2) - Remove [5x]
Disconnect the electrical connectors from the front floor console (1).
- Slide the front floor console (1) back enough to clear the instrument panel.
- NOTE:
Left side shown, right side similar.
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Outer Trim Cover- Right Side (1) - Remove
Instrument Panel Compartment Bolt (1) - Remove [5x]
Open the instrument panel compartment door.
- Instrument Panel Compartment Bolt (1) - Remove [3x]
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Compartment (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Outer Trim Cover- Left Side (1) - Remove
Instrument Panel Fuse Block Access Hole Cover (1) - Remove
- Instrument Panel Knee Bolster Bolt (2) - Remove [2x]
Using a flat-bladed plastic trim tool, release the retaining clips.
- Reposition the component to access the electrical connectors.
- Disconnect the electrical connectors.
- Instrument Panel Knee Bolster (1) - Remove
Instrument Panel Lower Trim Panel Bolt (1) - Remove [6x]
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Lower Trim Panel (2) - Remove
Instrument Panel Center Air Outlet Bolt (1) - Remove [8x]
- Instrument Panel Center Air Outlet (2) - Remove
Use a flat bladed plastic trim tool.
Use a flat bladed plastic trim tool.