Removal Procedure

NOTE:
Left side shown, right side similar.

Using a flat-bladed plastic trim tool, release the retaining clips on both sides of the vehicle.
Instrument Panel Outer Trim Cover- Left Side and Right Side (1) - Remove [2x]
NOTE:
Left side shown, right side similar.

Reposition the weatherstrip as necessary.
Use a flat-bladed plastic tool to disengage the retaining clip at the top of the body hinge pillar garnish molding (1) on both sides of the vehicle.
Body Hinge Pillar Garnish Molding- Left Side and Right Side (1) - Remove [2x]
NOTE:
Left side shown, right side similar.

Use a flat bladed plastic tool to disengage the windshield pillar assist handle covers (1) from the windshield garnish molding on both sides of the vehicle.
Windshield Pillar Assist Handle Cover- Left Side and Right Side (1) - Remove [4x]
Windshield Pillar Assist Handle Bolt- Left Side and Right Side (2) - Remove [4x]
NOTE:
Left side shown, right side similar.

Using a flat-bladed plastic trim tool, release the retaining clips on both sides of the vehicle.
Windshield Garnish Molding- Left Side and Right Side (1) - Remove [2x]
Disconnect the electrical connector.
NOTE:
Use a flat bladed plastic trim tool.

Reposition the instrument panel extension (1) to access the electrical connector.
Disconnect the electrical connector from the instrument panel extension (1).
Instrument Panel Extension (1) - Remove
NOTE:
Left side shown, right side similar.

Radio Front Speaker Grille Bolt (1) - Remove
Using a suitable plastic trim tool, release the retaining tabs.
Radio Front Speaker Grille- Right Side (2) - Remove
Instrument Panel Compartment Bolt (1) - Remove [5x]
Open the instrument panel compartment door.
Instrument Panel Compartment Bolt (1) - Remove [3x]
Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Compartment (1) - Remove
Instrument Panel Outer Air Outlet Bolt (1) - Remove [4x]
Using a suitable plastic trim tool, release the retaining tabs.
Instrument Panel Air Outlet Bezel (1) - Remove