Removal Procedure
Tire Repair Sealer and Tire Air Compressor Retainer (1) - Remove
- Tire Air Compressor (2) - Remove
Rear Floor Mat (1) - Remove
Move the front seat to access the retainers.
- Front Floor Console Bolt Access Hole Cover (1) - Remove
- Front Floor Console Rear Cover Bolt (2) - Remove
Move the front seat to access the retainers.
- Front Floor Console Bolt Access Hole Cover (1) - Remove
- Front Floor Console Rear Cover Bolt (2) - Remove
Open the armrest cover.
- Release the retainers with a suitable plastic trim tool.
- Front Floor Console Rear Trim Plate (1) - Remove
- Front Floor Console Rear Cover Bolt (2) - Remove [2x]
Release the retainers with a suitable plastic trim tool.
- Reposition the component to access the electrical connectors.
- Disconnect the electrical connectors.
- Front Floor Console Rear Trim Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Dual Charge Only Receptacle (1) - Remove
Heater and Air Conditioning Auxiliary Control Bolt (1) - Remove [4x]
- Heater and Air Conditioning Auxiliary Control (2) - Remove
Release the retaining tabs.
- Front Floor Console Rear Air Outlet (1) - Remove [2x]
Using a suitable plastic trim tool, release the retaining tabs.
- Accessory Power Receptacle (1) - Remove
Release the retaining tab.
- Low Frequency Console Number 2 Antenna (1) - Remove
NOTE:
Use a flat bladed plastic trim tool.
NOTE:
Use a flat bladed plastic trim tool.