Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Apply a liberal amount of lubricant to the pivot pocket, roller and valve slot areas of the camshaft followers. Adhesives, Fluids, Lubricants, and Sealers
- The follower must be positioned squarely on the valve tip so that the full width of the roller will completely contact the camshaft lobe. If the followers are being reused you must put them back in their original location.
- The rounded head end of the follower goes on the adjuster while the flat end goes on the valve tip.
- Place the camshaft followers in position on the valve tip and adjuster.
- Clean the camshaft journals and carriers with a clean, lint-free cloth.
- Valve Rocker Switching Arm (1) - Install [4x]
- Valve Rocker Arm (2) - Install [8x]
- Camshaft-Left Side - Install - Camshaft Replacement - Left Side
NOTE: