Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Install the NEW O-ring (1) on the oil level indicator tube (2).
Courtesy of GENERAL MOTORS COMPANY

Position the oil level indicator tube (1) by sliding the tube down and in to the approximate location of the lower crankcase hole.
Guide the lower portion of the oil level indicator tube into the lower crankcase hole and seat the oil level indicator tube in place.
Attach wiring harness retainers as necessary.
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Oil Level Indicator Tube Bracket Bolt (1) - Install and tighten 10 N.m (89 lb in)