Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Camshaft Housing Cover Insulator - Left Side (1) - Remove - Camshaft Housing Cover Insulator Replacement - Left Side
- Positive Crankcase Ventilation Tube @ Camshaft Cover - Disconnect
Ignition Coil (2) - Remove [3x] - Ignition Coil Replacement - Bank 2
Camshaft Position Actuator Valve Solenoid (1) - Remove - Camshaft Position Actuator Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust
Camshaft Position Actuator Valve Solenoid (1) - Remove - Camshaft Position Actuator Valve Solenoid Replacement - Bank 2 (Left Side) Intake
- Disconnect and remove the engine wiring harness from the camshaft cover.
Camshaft Cover Bolt (1) - Remove [18x]
- Camshaft Cover (2) - Remove
- Camshaft Cover Seal (3) - Remove and DISCARD
- Clean, inspect, and overhaul the camshaft cover as needed. Camshaft Cover Overhaul