Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Vacuum Pump Pipe Seal (2) - Install a NEW O-ring seal.
- Vacuum Pump Pipe (1) - Install
- CAUTION:
Refer to Fastener Caution .
Vacuum Pump Pipe Bolt (1) - Install and tighten to 10 N.m (89 lb in)
- {If equipped} Engine Oil Cooler - Install - Engine Oil Cooler Replacement (LGX)
Vacuum Pump Pipe Bolt (2) - Install and tighten to 10 N.m (89 lb in)
- Power Brake Booster Vacuum Hose (1) - Connect - Power Brake Booster Vacuum Hose Replacement (LGX)