Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Guide the oil pump flow control solenoid valve harness through the hole in the engine block and seat the harness connector (1).
- Install the oil pump flow control solenoid valve harness bolt (1) and tighten to 15 N.m (11 lb ft).
Connect the engine wiring harness electrical connector (1) to the oil pump flow control solenoid valve harness connector.
Install the oil pump flow control solenoid valve harness (1) to the crankshaft oil deflector retainers (2).
Install the oil pump flow control solenoid valve harness (2) to the retainer (3).
- Connect the oil pump flow control solenoid valve harness electrical connector (1) to the oil pump flow control solenoid valve.
- Oil Pan - Install - Oil Pan Replacement (AWD) , or Oil Pan Replacement (FWD)
CAUTION:
Refer to Fastener Caution .