Installation Procedure
WARNING: This page is about a different variant/trim than selected.
Place a suitable adjustable jack under the fuel tank.
- Fuel Tank (1) - Install
Fuel Tank Strap (2) - Install [2x]
- Fuel Tank Strap Bolt (1) - Install and tighten [4x] 22 N.m (16 lb ft)
Retainer (3) - Install
- Evaporative Emission Canister Vent Hose (2) - Connect - Plastic Collar Quick Connect Fitting Service
- Fuel Pump Fuel Feed Hose (1) - Connect - Plastic Collar Quick Connect Fitting Service
Evaporative Emission Canister Vent Hose (4) - Connect - Plastic Collar Quick Connect Fitting Service
- Fuel Tank Filler Hose (3) - Install
- Fuel Tank Filler Hose Clamp (2) - Tighten to 3.5 N.m (31 lb in)
- Wiring Harness (1) - Connect
- Refill the fuel tank.
- Inspect for fuel leaks.
CAUTION:
Refer to Fastener Caution .