Crankshaft Position Sensor Replacement (AWD)

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Power Transfer Unit Case Replacement (LGX)
1	Electrical Connector Procedure Disconnect the electrical connector.
2	Crankshaft Position Sensor Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
3	Crankshaft Position Sensor
4	Crankshaft Position Sensor Seal Procedure Install a NEW seal. Lubricate the NEW seal with clean engine oil.