Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | Electrical Connector |
| 2 | Camshaft Position Sensor Bolt
CAUTION:
Refer to Fastener Caution . Tighten 10 N.m (89 lb in) |
| 3 | Camshaft Position Sensor
WARNING:
Refer to Safety Glasses Warning . Procedure Use compressed air to remove debris from the Camshaft Position Sensor and surrounding cavities prior to removing the camshaft position sensor. |
| 4 | Camshaft Position Sensor Seal
NOTE:
Always install the camshaft position sensor O-ring supplied with the NEW camshaft position sensor. If reinstalling the sensor, inspect the camshaft position sensor O-ring and replace as necessary. Lubricate the camshaft position sensor O-ring with clean engine oil prior to installing the camshaft position sensor. |