Camshaft Position Actuator Locating Pin Control Valve Replacement - Bank 2

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Air Cleaner Assembly Replacement
1	Electrical Connector
2	Camshaft Position Actuator Locating Pin Control Valve Bolt CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
3	Camshaft Position Actuator Locating Pin Control Valve
4	Camshaft Position Actuator Solenoid Valve Seal Procedure Inspect the camshaft position actuator solenoid valve seal and replace as necessary. Use EN-46103 Camshaft Actuator Valve Seal Installer to install the seal if replacement is necessary. Special Tools EN-46103 Camshaft Actuator Valve Seal Installer Equivalent regional tools: Special Tools