LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2022 >> Acadia SLE, 4WD >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Trim, And Upholstery >> Repair Instructions >> Front Seat Cushion Frame Replacement (Power)

Front Seat Cushion Frame Replacement (Power)

GM4531594Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Front Seat Cushion Cover and Pad Replacement 
1 Front Seat Cushion Frame Bolt [4x]
CAUTION:

Refer to Fastener Caution .

  1. Remove the seat back frame bolts.
  2. If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
    1. Remove any loose cured adhesive from the external threads of the component using a lint free cloth.
    2. Thread the cleaned component into the internal mating threads and remove to loosen trapped cured adhesive.
    3. Apply thread locking adhesive to the external threads of the component. Adhesives, Fluids, Lubricants, and Sealers 
    4. Ensure there are no gaps in the thread locking adhesive once applied to the component.

Tighten 
45 N.m (33 lb ft)
2 Front Seat Cushion Frame
NOTE:

The new cushion frame may not have adjuster stops installed. Transfer the adjuster stops from original frame or install new as needed. The frame may need to be adjusted to access the adjuster stops.

Procedure

  1. Disconnect the electrical connector.
  2. Transfer components as necessary.
scientia non olet · About LEMON Manuals