Installation Procedure
Ignition Coil (3) @ Valve Rocker Arm Cover (1) Install - [ 4x ]
- Ignition Coil Bolt (2) - Install and hand tighten [ 8x ]
- Ignition Coil Bolt (2) - Tighten [ 8x ] - Fastener Specifications
Valve Rocker Arm Cover Insulator Retainer (1) - Install and tighten [ 3x ] - Fastener Specifications
Valve Rocker Arm Cover Gasket (2) @ Valve Rocker Arm Cover (1) - Install NEW
- NOTE:
Some components not shown for graphic clarity.
Valve Rocker Arm Cover- Right Side (2) - Install
- Valve Rocker Arm Cover Bolt (1) - Hand tighten [ 10x ]
- Valve Rocker Arm Cover Bolt (1) - Tighten in sequence [ 10x ] - Fastener Specifications
- Engine Wiring Harness Connector @ Ignition Coil - Connect [ 4x ]
Inspect the inside of the spark plug rubber boot for a thin even coat of grease. If there is no grease present or additional grease is necessary, apply a thin coating of dielectric grease evenly to the inside of the spark plug rubber boot up to a depth of 15 mm from the end of the boot. Adhesives, Fluids, Lubricants, and Sealers
- Push the 4 spark plug wire boots (1) onto the 4 ignition coils (2) until two audible clicks are heard.
Heater Inlet and Outlet Hose Bracket (2) - Reposition
- Heater Hose Clip Bracket Bolt (1) - Install and tighten - Fastener Specifications
Valve Rocker Arm Cover Insulator (3) - Install
- Install the 3 upper intake manifold sight shield grommets (1) to the 3 valve rocker arm cover insulator retainers (2).
Positive Crankcase Ventilation Tube Connector (3) @ Positive Crankcase Ventilation Fitting - Install - Plastic Collar Quick Connect Fitting Service
Refer to Fastener Caution .