Removal Procedure
- NOTE:
Some components not shown for graphic clarity.
Positive Crankcase Ventilation Tube Connector (1) @ Positive Crankcase Ventilation Fitting - Disconnect - Plastic Collar Quick Connect Fitting Service
- Positive Crankcase Ventilation Tube Connector (2) @ Intake Manifold - Disconnect - Plastic Collar Quick Connect Fitting Service
- Positive Crankcase Ventilation Foul Air Tube (3) - Remove
Grasp the valve rocker arm cover insulator (3) and lift up disengaging the 3 upper intake manifold sight shield grommets (2) from the 3 valve rocker arm cover insulator retainers (1).
- Valve Rocker Arm Cover Insulator (3) - Remove
- Inspect the 3 upper intake manifold sight shield grommets (2) on the valve rocker arm cover insulator and replace as necessary.
- Engine Wiring Harness - Reposition
- NOTE:
- Pull only on the spark plug wire boot to remove the wire.
- Inspect the spark plug wire for damage and replace if necessary.
Twist the 4 spark plug wire boots a 1/2 turn and remove the 4 spark plug wires (1) from the 4 ignition coils (2).
- Engine Wiring Harness Connector @ Ignition Coil - Disconnect [ 4x ]
Fuel Feed Pipe Bolt (1) @ Fuel Feed Pipe (2) - Remove
- Fuel Feed Pipe (2) - Reposition
Valve Rocker Arm Cover Bolt (1) - Loosen until disengaged [ 9x ]
- Valve Rocker Arm Cover- Left Side (2) - Remove
Valve Rocker Arm Cover Gasket (2) @ Valve Rocker Arm Cover (1) - Remove and DISCARD
Rotate the oil filler tube (1) counterclockwise and remove from the valve rocker arm cover.
Inspect the oil filler tube seal (2) on the oil filler tube (1) and replace as necessary.
Valve Rocker Arm Cover Insulator Retainer (1) - Remove [ 3x ]
Ignition Coil Bolt (2) - Remove [ 8x ]
- Ignition Coil (3) @ Valve Rocker Arm Cover (1) - Remove [ 4x ]