LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Yukon XL AT4 >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 5.3L (L84) Or 6.2L (L87) - Repair Instructions (10 Of 12) >> Repair Instructions >> Oil Level Indicator Tube Replacement >> Installation Procedure

Installation Procedure

  1. GM5535978Courtesy of GENERAL MOTORS COMPANY

    Oil Level Indicator Seal (2) - Install NEW

  2. Lubricate the NEW oil level indicator seal (2) with clean engine oil. Adhesives, Fluids, Lubricants, and Sealers
  3. Oil Level Indicator Tube (1) @ Oil Pan - Install
  4. Raise and support the vehicle. Lifting and Jacking the Vehicle
  5. GM5535977Courtesy of GENERAL MOTORS COMPANY

    Engine Wiring Harness (3) - Install

  6. Engine Wiring Harness Retainer (1) @ Oil Level Indicator Tube (2) - Connect
  7. Remove the support and lower the vehicle.
  8. GM5535975Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Oil Level Indicator Tube Bolt (1) - Install and tighten - Fastener Specifications

  9. GM5535974Courtesy of GENERAL MOTORS COMPANY

    Install the oil level indicator. (1)

scientia non olet · About LEMON Manuals