Removal Procedure
- Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
Remove the oil level indicator. (1)
Oil Level Indicator Tube Bolt (1) - Remove
- Front Wheelhouse Liner- Right Side - Remove - Front Wheelhouse Liner Replacement
Engine Wiring Harness Retainer (1) @ Oil Level Indicator Tube (2) - Disconnect
- Engine Wiring Harness (3) - Reposition
Oil Level Indicator Tube (1) @ Oil Pan - Remove
- Oil Level Indicator Tube (1) - Remove
- Oil Level Indicator Seal (2) - Remove and DISCARD
- Wiring Harness - Position aside
Exhaust Manifold Heat Shield Bolt- Right Side (1) - Remove [ 3x ]
Remove the right exhaust manifold heat shield (1) through the wheel opening.
Exhaust Heat Shield Bolt (1) - Remove
- Exhaust Front Pipe Heat Shield- Right Side (2) - Remove
Disconnect the heated oxygen sensor electrical connector.
Exhaust Front Pipe Nut- Right Side (1) - Remove [ 3x ]
- NOTE:
Pull only on the spark plug wire boot to remove the wire.
NOTE:Inspect the spark plug wire for damage and replace if necessary.
Twist the 4 spark plug wire boots a 1/2 turn and remove the 4 spark plug wires (1) from the 4 gas engine ignition spark plugs (2).
Exhaust Manifold Bolt (1) - Remove and DISCARD [ 5x ]
Remove the right side exhaust manifold (1) through the wheel opening.
- Exhaust Manifold Gasket- Right Side (2) - Remove and DISCARD
Exhaust System Seal (1) - Remove and DISCARD
- NOTE:
Work through the front wheelhouse opening to access the 3 engine mount frame side bolts (1).
Engine Mount Frame Side Bolt- Right Side (1) - Remove [ 3x ]
Install EN-36857 Engine Lift Bracket (1) to the front of the right side cylinder head as shown using EN-51768 Engine Support Fixture Adaptor Bolt - M8.
- Raise the engine using a suitable lifting device to remove the engine mount.
- NOTE:
Work through the front wheelhouse opening to access the 4 engine mount engine side bolts (1).
Engine Mount Engine Side Bolt- Right Side (1) - Remove [ 4x ]
Engine Mount- Right Side (1) - Remove
When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Lifting the engine in an unapproved manner may cause component damage.
When raising the engine only raise enough to separate the engine mount from the engine mount bracket. Raising any further will require removal of the fan shroud or the exhaust pipe.