Removal Procedure
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Engine Oil and Oil Filter - Remove and DISCARD - Engine Oil and Oil Filter Replacement
- Transmission - Remove - Automatic Transmission Removal and Installation (L84, L87, 4WD and NP0) , or Automatic Transmission Removal and Installation (L84, L87, 4WD and NQH) .
Position the EN-42386 Flywheel Holding Tool (1) into place.
- Install the M10-1.5 x 120 mm (3) and the M10-1.5 x 45 mm (2) bolts and tighten to 50 N.m (37 lb-ft).
- NOTE:
Note the position and direction of the automatic transmission flex plate before removal.
Automatic Transmission Flex Plate Bolt (1) - Remove and DISCARD [ 8x ]
Automatic Transmission Flex Plate (1) - Remove
- If the crankshaft rear oil seal cover is reused perform the following steps:
Install the EN-51096 Seal Remover (2) to the GE-23907-1 Slide Hammer with Shaft (1).
- Slide the small bend of the EN-51096 Seal Remover (2) between the lip of the crankshaft rear oil seal and crankshaft. Ensure that the small bend of the EN-51096 Crankshaft Rear Seal Remover (2) engages the rear side of the crankshaft rear oil seal (3).
- Using the EN-51096 Seal Remover (2) and GE-23907-1 Slide Hammer with Shaft (1) remove the crankshaft rear oil seal (3).
Crankshaft Rear Oil Seal (1) - Remove and DISCARD
NOTE:EN-51096 Crankshaft Rear Seal Remover (2) has two ends. The end with the small bend will be used to remove the crankshaft rear oil seal (3).
Oil Pan Bolt (1) - Loosen until disengaged [ 2x ]
Crankshaft Rear Oil Seal Housing Bolt (1) - Loosen until disengaged [ 12x ]
- Crankshaft Rear Oil Seal Housing (2) - Remove
If reusing the crankshaft rear oil seal housing (2), remove and DISCARD the crankshaft rear oil seal housing gasket (1) from the crankshaft rear oil seal housing (2).
If the crankshaft rear oil seal cover is reused, the crankshaft rear oil seal must be replaced.