Cleaning Procedure
WARNING:
Refer to Safety Glasses Warning .
NOTE:
- When cleaning a cylinder head in a thermal type oven, do Not exceed 204°C (400°F).
- Be careful not to scuff the chamber.
Clean the following components:
- Combustion Chamber
Use the EN-8089 Carbon Removal Brush to remove the carbon from the combustion chambers.
- Fuel Injector Bores
Use the EN-47909 Injector Bore Brush Kit to remove the carbon from the fuel injector bores.
- Gasket surfaces - Replacing Engine Gaskets
- Valve stems and heads on a buffing wheel
- Bolt hole threads
Remove all dirt, debris, or threadlocking material from the bolt holes.