Removal Procedure

Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Skid Plate Bolt (1) - Remove [ 4x ]
Underbody Splash Shield Bolt (2) - Remove [ 4x ]
Courtesy of GENERAL MOTORS COMPANY

Underbody Splash Shield (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Underbody Splash Shield Bolt (2) - Remove [ 2x ]
Underbody Skid Shield (3) - Remove
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- The accessory drive primary belt is not reusable.
- Some components not shown for graphic clarity.
Using a suitable tool, cut the accessory drive primary belt (1).
Accessory Drive Primary Belt (1) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The accessory drive auxiliary belt is not reusable.

Using a suitable tool, cut the accessory drive auxiliary belt (1).
Accessory Drive Auxiliary Belt (1) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- The balancer holding kit (4) should be assembled as it is installed on the crankshaft balancer (2).
- Some components not shown for graphic clarity.
Install the EN-52287 Balancer Holding Kit (4) and the EN-956-1 Extension Bar (3) to the crankshaft balancer (2).
Hold the EN-52287 Balancer Holding Kit (4) with the EN-956-1 Extension Bar (3) and remove and DISCARD the crankshaft balancer bolt (1).
Remove the EN-52287 Balancer Holding Kit (4) and the EN-956-1 Extension Bar (3) from the crankshaft balancer (2).
Courtesy of GENERAL MOTORS COMPANY

Install the EN-41816-A Crankshaft Balancer Remover (1) and the EN-44226-5 Crankshaft Protector (3) to the crankshaft balancer (2).
Courtesy of GENERAL MOTORS COMPANY

Using the EN-41816-A Crankshaft Balancer Remover (1) with the EN-44226-5 Crankshaft Protector (2) remove crankshaft balancer (3) from the crankshaft.
Remove the EN-41816-A Crankshaft Balancer Remover (1) and the EN-44226-5 Crankshaft Protector (2) from the crankshaft balancer (3).
Courtesy of GENERAL MOTORS COMPANY

Install the EN-51096 Seal Remover (2) to the GE-23907-1 Slide Hammer with Shaft (1).

NOTE:

EN-51096 Crankshaft Seal Remover (2) has two ends. The end with the larger bend will be used to remove the crankshaft front oil seal (3).

Slide the large bend of the EN-51096 Seal Remover (2) between the lip of the crankshaft front oil seal and crankshaft. Ensure that the larger bend of the EN-51096 Crankshaft Seal Remover (2) engages the rear side of the crankshaft front oil seal (3).
Using the EN-51096 Seal Remover (2) and the GE-23907-1 Slide Hammer with Shaft (1) remove the crankshaft front oil seal (3).
Courtesy of GENERAL MOTORS COMPANY

Crankshaft Front Oil Seal (1) - Remove and DISCARD