Assemble Procedure
Oil Pan Front Seal (3) - Install NEW
- Oil Pan High Pressure Port Seal (2) - Install NEW
- NOTE:
Ensure proper use of room temperature vulcanizing (RTV) sealant. Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
Apply a 3 mm (0.118 in) bead of RTV sealant on the engine front cover, engine block, and crankshaft rear oil seal housing as shown (1). Apply a 5 mm (0.197 in) bead of RTV sealant at the corner areas as shown (2). Adhesives, Fluids, Lubricants, and Sealers
- NOTE:
Install and align the oil pan within 10 minutes of applying the sealer.
Oil Pan (3) - Install
- Oil Pan Bolt (1, 2) - Install and tighten in sequence [ 16x ] - Fastener Specifications
- NOTE:
Left side shown, right side similar.
Cylinder Head Gasket (5) - Install NEW
- Cylinder Head (4) - Install
- Cylinder Head Bolt (2) - Install NEW and hand tighten [ 10x ]
- Cylinder Head Bolt (3) - Tighten in sequence [ 10x ] - Fastener Specifications
- Connect the valve rocker arm oil control valve extension harness connector (1) to the valve rocker arm oil control valve harness.
- NOTE:
Left side shown, right side similar.
Valve Push Rod (2) - Install [ 8x ]
- Valve Rocker Arm (1) - Install [ 16x ] - Fastener Specifications
- NOTE:
Left side shown, right side similar.
Valve Rocker Arm Cover Gasket (1) - Install NEW [ 2x ]
- Valve Rocker Arm Cover (2) - Install [ 2x ]
- Valve Rocker Arm Cover Bolt (3) - Install and tighten in sequence [ 19x ] - Fastener Specifications
- Push the boot of the spark plug wire (8) onto the gas engine ignition spark plug until 2 audible clicks are heard.