LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Yukon XL AT4 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Rear Brake Pipe Connector Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
  2. Raise and support the vehicle. Lifting and Jacking the Vehicle
  3. Remove the front tire and wheel assembly. Tire and Wheel Removal and Installation (Aluminum Wheel)
  4. GM5522093Courtesy of GENERAL MOTORS COMPANY

    {If equipped} Front Tire Front Air Deflector Bolt (1) - Remove

  5. GM5513747Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Liner Bolt (1) - Remove [ 3x ]

  6. GM5513749Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Quantity of fasteners may vary based on option content.

    Front Wheelhouse Liner Bolt (1) - Remove [ 3x ]

  7. Front Wheelhouse Liner Retainer (2) - Remove
  8. GM5513751Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Liner Bolt (1) - Remove [ 3x ]

  9. GM5513753Courtesy of GENERAL MOTORS COMPANY

    Front Wheelhouse Liner Bolt (1) - Remove [ 3x ]

  10. Remove the front wheelhouse liner.
  11. GM5568612Courtesy of GENERAL MOTORS COMPANY

    Front And Rear Brake Pipe Nut (2) @ Rear Brake Pipe Connector - Remove [ 2x ]

  12. Front And Rear Brake Pipe (1) @ Rear Brake Pipe Connector - Remove [ 2x ]
  13. Rear Brake Rear Pipe Nut (3) @ Rear Brake Pipe Connector - Remove [ 2x ]
  14. Rear Brake Rear Pipe (4) @ Rear Brake Pipe Connector - Remove [ 2x ]
  15. Cap the front and rear brake pipe (4) outlets and the rear brake rear pipe (2) inlets to avoid fluid loss and contamination.
  16. GM5568611Courtesy of GENERAL MOTORS COMPANY

    Rear Brake Pipe Connector Bolt (1) - Remove

  17. Rear Brake Pipe Connector (2) - Remove