LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Yukon XL AT4 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Rear Brake Hose Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
  2. Raise and support the vehicle. Lifting and Jacking the Vehicle
  3. Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation (Aluminum Wheel)
  4. GM5537622Courtesy of GENERAL MOTORS COMPANY

    Rear Brake Hose Bracket Bolt (1) - Remove [ 2x ]

  5. Rear Brake Hose Bracket (2) - Remove [ 2x ]
  6. GM5537740Courtesy of GENERAL MOTORS COMPANY

    Rear Brake Hose Fitting (1) - Remove

  7. Rear Brake Hose Washer (2) - Remove and DISCARD [ 2x ]
  8. Rear Brake Hose (3) @ Rear Brake Caliper - Remove
  9. Plug the rear brake hose outlet to prevent brake fluid loss and contamination.
  10. Plug the rear brake caliper inlet to prevent brake fluid loss and contamination.
  11. GM5537621Courtesy of GENERAL MOTORS COMPANY

    Rear Brake Rear Pipe Nut (1) - Remove

  12. Rear Brake Hose Clip (2) - Remove
  13. Rear Brake Hose (3) - Remove
  14. Plug the rear brake hose inlet to prevent brake fluid loss and contamination.
  15. Cap the rear brake rear pipe outlet to prevent brake fluid loss and contamination.
scientia non olet · About LEMON Manuals