Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Rear Brake Crossover Pipe (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Remove the plug from the rear brake rear pipe inlet.

CAUTION:

Fastener Caution

Rear Brake Crossover Pipe Nut (1) - Install and tighten - Fastener Specifications
Rear Brake Crossover Pipe Retainer (2) - Install [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Crossover Pipe Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Crossover Pipe Retainer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Brake Crossover Pipe (1) @ Retainer Clip - Install
Courtesy of GENERAL MOTORS COMPANY

Remove the plug from the rear brake front pipe outlet.
Rear Brake Crossover Pipe Nut (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Wheelhouse Liner (1) - Install [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Wheelhouse Liner Bolt (1) - Install and tighten [ 14x ] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Wheelhouse Liner Bolt (1) - Install and tighten [ 6x ] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Wheelhouse Liner Retainer (2) - Install [ 2x ]
Rear Wheelhouse Liner Bolt (1) - Install and tighten [ 8x ] - Fastener Specifications
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
Bleed the brake system. Hydraulic Brake System Bleeding
Install the rear tire and wheel assemblies. Tire and Wheel Removal and Installation (Aluminum Wheel)
Remove the support and lower the vehicle.
Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Brake Master Cylinder Reservoir Filling