Installation Procedure
Lubricate the brake master cylinder reservoir seals (1) with GM approved brake fluid from a clean, sealed brake fluid container. Adhesives, Fluids, Lubricants, and Sealers
- Brake Master Cylinder Reservoir Seal (1) - Install NEW [ 3x ]
Brake Master Cylinder Reservoir (1) - Install
- CAUTION:
Refer to Fastener Caution .
Brake Master Cylinder Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
Electrical Connector (1) @ Brake Fluid Level Indicator Switch - Connect
- Front Wheelhouse Liner - Left Side - Install Front Wheelhouse Liner Replacement
- Install the left front tire and wheel assembly. Tire and Wheel Removal and Installation (Aluminum Wheel)
- Remove the support and lower the vehicle.
{If equipped} Front Tire Front Air Deflector Bolt (1) - Install and tighten - Fastener Specifications
Radiator Surge Tank (1) - Install
Radiator Surge Tank Bolt (1) - Install and tighten - Fastener Specifications
Air Cleaner Upper Housing (2) - Install
- Air Cleaner Housing Cover Bolt (1) - Install and tighten [ 3x ] - Fastener Specifications
- Connect the mass airflow sensor electrical connector.
Air Cleaner Outlet Front Duct (2) - Install
- Air Cleaner Outlet Duct Clamp (1) - Tighten [ 2x ] - Fastener Specifications
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection (KL9)
- Fill the brake master cylinder reservoir to the maximum-full level with GM approved brake fluid from a clean, sealed brake fluid container. Brake Master Cylinder Reservoir Filling
CAUTION:
Refer to Fastener Caution .