LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Yukon XL AT4 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Rear Side Door Wiring Harness Replacement >> Removal Procedure

Removal Procedure

  1. Rear Side Door Trim - Remove - Rear Side Door Trim Removal and Installation
  2. GM5521064Courtesy of GM

    Radio Rear Side Door Speaker Bolt (1) - Remove

  3. Radio Rear Side Door Speaker (2) - Remove
  4. Disconnect the electrical connector.
  5. GM5569015Courtesy of GM

    Rear Side Door Trim Bolt (1) - Remove [2x]

  6. Rear Side Door Pull Handle Bracket (2) - Remove
  7. GM5539412Courtesy of GM

    Route the rear side door inside handle cable through hole in the rear side door water deflector (1).

  8. Rear Side Door Water Deflector (1) - Remove
  9. GM5598399Courtesy of GM
    NOTE:

    Typical wiring harness shown, individual harness may be different due to option content.

    Rear Side Door Wiring Harness (1) - Remove