Removal Procedure

Courtesy of GM

Front Bumper Fascia (2) - Remove - Front Bumper Fascia Removal and Installation (with WTX) , or Front Bumper Fascia Removal and Installation (with RC1)
Courtesy of GM

Hood Primary and Secondary Latch Bolt (1) - Remove [2x]
Disconnect the electrical connector and harness retainer.
Hood Primary and Secondary Latch (2) - Remove
Disconnect the hood primary latch release cable (3) from the hood primary latch.
Courtesy of GM

Reposition the hood primary latch release cable (1) from the upper tie bar.
Courtesy of GM

Headlamp Bolt (1) - Remove [6x]
Courtesy of GM

Headlamp Bolt (1) - Remove [6x]
Courtesy of GM

Release the front headlamp guide pin from the front bumper fascia guide (1).
Front Headlamp (2) - Remove [2x]
Release the wiring harness retaining tab.
Disconnect all electrical connectors.
Courtesy of GM

Loosen the left and right side front bumper fascia upper stiffener nut (1).
Remove the left and right side front bumper fascia upper stiffener bolt (2).
Courtesy of GM

Pull the front bumper fascia upper stiffener (1) up and out over the stud.
Courtesy of GM

Ambient Air Temperature Sensor (1) - Remove
Disconnect the electrical connector. (2)
Courtesy of GM

Front Bumper Shutter Bolt (1) - Remove [9x]
Disconnect the electrical connector and reposition wiring harness.
Front Bumper Shutter (2) - Remove
Courtesy of GM

Front Grille Support Bracket Bolt (1) - Remove [4x]
Front Grille Support Reinforcement (2) - Remove
Courtesy of GM

Front End Upper Tie Bar Bolt (1) @ Headlamp Bracket - Remove [2x]
Courtesy of GM

Headlamp Bolt (1) - Remove [2x]
Headlamp Bracket (2) - Remove [2x]
Courtesy of GM
NOTE:
- Some components not shown for graphic clarity.
- Right side shown, left side similar.
Front End Sheet Metal Diagonal Brace Bolt (1) - Remove [2x]
Front End Sheet Metal Diagonal Brace @ Radiator (2) - Remove [2x]
Courtesy of GM

Front End Sheet Metal Diagonal Brace Bolt (1) - Remove [4x]
Front End Sheet Metal Diagonal Brace @ Upper Tie Bar (2) - Remove [2x]
Courtesy of GM

Radiator Air Upper Baffle (1) - Remove
Courtesy of GM

Horn Nut (1) - Remove
Disconnect the electrical connector.
Dual Horn (2) - Remove
Courtesy of GM

Intake Air Duct Retainer (1) - Remove
Intake Air Duct (2) - Reposition
Courtesy of GM

Front End Upper Tie Bar Bolt (1) - Remove [3x]
Courtesy of GM

Front End Upper Tie Bar Bolt (1) - Remove
Courtesy of GM

Front End Upper Tie Bar Bolt (1) - Remove [3x]
Courtesy of GM

Front End Upper Tie Bar Bolt (1) - Remove
Disconnect the wiring harness retainers and reposition the harness as necessary.
Courtesy of GM

Front End Upper Tie Bar (1) - Remove