Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Pad Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Disconnect the electrical connector.

NOTE:

Use care not to bend or deform the thin area of the instrument panel trim pad.

Instrument Panel Trim Pad (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Depress the retaining tabs on the on/off vehicle switch (1).
On/Off Vehicle Switch (1) - Remove