Installation Procedure
Instrument Panel Lower Trim Panel (2) - Install
- Instrument Panel Lower Trim Panel Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
Rear Floor Console Applique (2) - Install
- Front Floor Console Trim Plate Bolt (1) - Install and tighten [ 3x ] - Fastener Specifications
Front Floor Console Applique (1) - Install
Instrument Panel Knee Bolster (1) - Install
Connect the electrical connector.
- Instrument Panel Trim Pad (2) - Install
- Instrument Panel Trim Pad Bolt (1) - Install and tighten - Fastener Specifications
Instrument Panel Fuse Block Access Hole Cover (1) - Install
Instrument Panel Knee Bolster Bolt (2) - Install and tighten [ 2x ] - Fastener Specifications
- Hood Primary Latch Release Cable Handle (1) - Install
Connect the electrical connectors.
- Instrument Panel Switch Trim Plate (2) - Install
- Instrument Panel Switch Trim Plate Bolt (1) - Install and tighten - Fastener Specifications
Connect the electrical connectors.
- Instrument Panel Trim Pad (2) - Install
- Instrument Panel Trim Pad Bolt (1) - Install and tighten - Fastener Specifications
Instrument Panel Fuse Block Access Hole Cover (1) - Install
Instrument Panel Lower Trim Panel Outer Filler (1) - Install
Connect the electrical connector.
- Front Floor Courtesy Lamp (1) - Install
Rotate the front floor courtesy lamp (1) a quarter turn clockwise to secure.
- Secure the retaining tab.
Instrument Panel Lower Trim Panel Insulator (1) - Install
Instrument Panel Lower Insulator Retainer (1) - Install [ 2x ]
Refer to Fastener Caution .