Removal Procedure
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Lower Applique (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Applique (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Trim Plate Applique (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Center Trim Plate Applique (1) - Remove
Instrument Panel Upper Trim Panel Bolt (1) - Remove [ 6x ]
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Disconnect the electrical connector.
- Instrument Panel Trim Pad (2) - Remove
Instrument Panel Lower Trim Panel Bolt (1) - Remove
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Lower Center Trim Plate Applique (2) - Remove
NOTE:
Use care not to bend or deform the thin area of the instrument panel trim pad.