Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Insulator Retainer (1) - Remove [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Insulator (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Release the retaining tab.
Rotate the front floor courtesy lamp (1) a quarter turn counterclockwise to release.
Courtesy of GENERAL MOTORS COMPANY

Front Floor Courtesy Lamp (1) - Remove
Disconnect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Outer Filler (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Pad Bolt (1) - Remove
Disconnect the electrical connectors.
Instrument Panel Trim Pad (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Switch Trim Plate Bolt (1) - Remove
Disconnect the electrical connectors.
Instrument Panel Switch Trim Plate (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Hood Primary Latch Release Cable Handle (1) - Release
Instrument Panel Knee Bolster Bolt (2) - Remove [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Pad Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Disconnect the electrical connector.

NOTE:

Use care not to bend or deform the thin area of the instrument panel trim pad.

Instrument Panel Trim Pad (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
You may have to push down on the lower steering column closeout to clear the instrument panel cluster trim plate.

Instrument Panel Knee Bolster (1) - Remove