Installation Procedure

CAUTION:

Instrument Panel Driver Knee Bolster Brace Bolt (1) - Install and tighten [ 4x ] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Carrier Bolt (1) - Install and tighten [ 3x ] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Route the hood release cable to its proper position

Instrument Panel Lower Trim Panel Insulator (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Insulator Retainer (1) - Install [ 2x ]
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Knee Bolster (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connector.
Instrument Panel Knee Bolster Bolt (2) - Install and tighten [ 2x ] - Fastener Specifications
Hood Primary Latch Release Cable Handle (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connectors.
Instrument Panel Switch Trim Plate (2) - Install
Instrument Panel Switch Trim Plate Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Connect the electrical connectors.
Instrument Panel Trim Pad (2) - Install
Instrument Panel Trim Pad Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Fuse Block Access Hole Cover (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Lower Trim Panel Outer Filler (1) - Install