Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Applique (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Trim Plate Bolt (1) - Remove [ 3x ]
Rear Floor Console Applique (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Trim Pad Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Disconnect the electrical connector.

NOTE:

Use care not to bend or deform the thin area of the instrument panel trim pad.

Instrument Panel Trim Pad (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Lower Trim Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Compartment Bolt (1) - Remove [ 2x ]
Using a flat-bladed plastic trim tool, release the retaining clips.
Instrument Panel Lower Trim Panel Outer Filler (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Compartment Bolt (1) - Remove [ 10x ]
Courtesy of GENERAL MOTORS COMPANY

Instrument Panel Compartment (1) - Remove