Removal Procedure
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Applique (1) - Remove
Front Floor Console Trim Plate Bolt (1) - Remove [ 3x ]
- Rear Floor Console Applique (2) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Applique (1) - Remove
Front Floor Console Trim Plate Bolt (1) - Remove [ 3x ]
- Rear Floor Console Applique (2) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Fuse Block Access Hole Cover (1) - Remove
Instrument Panel Trim Pad Bolt (1) - Remove
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Disconnect the electrical connector.
- Instrument Panel Trim Pad (2) - Remove
Instrument Panel Bolt (1) - Remove [ 5x ]
- Instrument Panel Center Trim Plate Applique (2) - Remove
Instrument Panel Accessory Trim Plate Bolt (1) - Remove [ 4x ]
- Instrument Panel Center Trim Plate Applique (2) - Remove
Instrument Panel Accessory Bezel Bolt (1) - Remove
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Transmission Shift Opening Cover (2) - Remove
Electronic Transmission Shift Control Pushbutton Bolt (1) - Remove [ 3x ]
- Electronic Transmission Shift Control Pushbutton (2) - Remove
- Disconnect the electrical connector.
Radio Control Bolt (1) - Remove [ 5x ]
Disconnect the electrical connectors.
- Radio Control (1) - Remove
Radio Control Bracket Bolt (1) - Remove [ 4x ]
- Instrument Panel Accessory Bezel (2) - Remove
Heater and Air Conditioning User Interface Control Bolt (1) - Remove [ 4x ]
- Heater and Air Conditioning User Interface Control (2) - Remove
Use care not to bend or deform the thin area of the instrument panel trim pad.