Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Rear Cup Holder Liner (1) - Remove
Front Floor Console Cup Holder Bolt (2) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Rear Cup Holder (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Front Floor Console Rear Cover Bolt (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
Front Floor Console Rear Trim Panel (2) - Remove
Disconnect the electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Front Floor Compartment Bolt (1) - Remove [ 4x ]
Front Floor Rear Console Trim Plate (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disengage the retaining tab that secures the antenna to the panel.
Low Frequency Console Number 2 Antenna (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using a suitable plastic trim tool, release the retaining tabs.
Front Floor Console Accessory Power Rear Receptacle (1) - Remove