Removal Procedure
Front Seat (2) - Remove [ 2x ] - Front Seat Removal and Installation
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Applique (1) - Remove
Front Floor Console Trim Plate Bolt (1) - Remove [ 3x ]
- Rear Floor Console Applique (2) - Remove
- NOTE:
Use a flat bladed plastic trim tool.
Front Floor Console Extension Panel Bolt Access Hole Cover (1) - Remove
- Front Floor Console Extension Bolt (2) - Remove
- Front Floor Console Extension Panel (3) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Bolt Access Hole Cover (1) - Remove
- NOTE:
You may have to slide the armrest back to better access the retainers.
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Rear Trim Lower Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Rear Console Side Trim Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Applique (1) - Remove
Front Floor Console Trim Plate Bolt (1) - Remove [ 3x ]
- Rear Floor Console Applique (2) - Remove
- NOTE:
Use a flat bladed plastic trim tool.
Front Floor Console Extension Panel (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Front Floor Console Bolt Access Hole Cover (1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Disconnect and reposition harness as necessary.
- Front Floor Rear Console Side Trim Panel (1) - Remove
Front Floor Console Storage Tray Bolt (1) - Remove [ 2x ]
Front Floor Console Storage Tray Bolt (2) - Remove [ 2x ]
Front Floor Console Stowage Tray (1) - Reposition
Front Floor Console Bolt (1) - Remove [ 2x ]
- Front Floor Console Retainer Bolt (2) - Remove
Front Floor Console Retainer Bolt (1) - Remove
- Front Floor Console Bolt (2) - Remove [ 2x ]
Slide the front floor console (1) back to clear the instrument panel accessory bezel.
Pull up on the rear of the front floor console cup holder trim plate (1) to start to release the retainer clips and work your way forward.
- Disconnect the electrical connectors.
- Front Floor Console Cup Holder Trim Plate (1) - Remove
Disconnect and reposition harness as necessary.
- Front Floor Console Intermediate Bracket Bolt (1) - Remove [ 4x ]
- Front Floor Console Carrier (2) - Remove
Front Floor Console Auxiliary Cooling Duct Retainer (1) - Remove
- Front Floor Console Auxiliary Cooling Intermediate Duct (2) - Remove