Installation Procedure
Connect the electrical connectors.
- Instrument Cluster (2) - Install
- Instrument Cluster Bolt (1) - Install and tighten [ 4x ] - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Cluster Trim Plate (1) - Install
Instrument Panel Cluster Trim Plate Bolt (1) - Install and tighten [ 7x ] - Fastener Specifications
Secure the instrument panel steering column upper trim cover (1) to the instrument panel steering column lower trim cover.
Connect the electrical connectors.
- Instrument Panel Trim Pad (2) - Install
- Instrument Panel Trim Pad Bolt (1) - Install and tighten - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Trim Pad (2) - Install
- Instrument Panel Trim Pad Bolt (1) - Install and tighten - Fastener Specifications
Instrument Panel Fuse Block Access Hole Cover (1) - Install
Instrument Panel Upper Trim Panel (2) - Install
- Instrument Panel Upper Bolt (1) - Install and tighten [ 3x ] - Fastener Specifications
Instrument Panel Fuse Block Access Hole Cover (1) - Install
Instrument Panel Lower Trim Panel Outer Filler (1) - Install
Instrument Panel Instrument Cluster Hood (3) - Install
- Instrument Panel Upper Bolt (2) - Install and tighten [ 4x ] - Fastener Specifications
- Instrument Panel Upper Trim Panel Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
Connect the electrical connector.
- Radio Front Center Speaker (2) - Install
- Radio Front Center Speaker Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Extension (1) - Install
Windshield Garnish Molding Bolt (2) - Install and tighten - Fastener Specifications
- Connect the electrical connector.
- Windshield Garnish Molding (1) - Install
- Enable the SIR System. SIR Disabling and Enabling
- Perform the necessary programming and setup procedure: Control Module References
Refer to Fastener Caution .