Installation Procedure
Connect the electrical connector.
- Head-Up Display (2) - Install
- Head-Up Display Bolt (1) - Install and tighten [ 4x ] - Fastener Specifications
Head-Up Display Bezel (1) - Install
Instrument Panel Upper Trim Panel Bolt (1) - Install and tighten - Fastener Specifications
- Instrument Panel Upper Bolt (2) - Install and tighten [ 5x ] - Fastener Specifications
Connect the electrical connector.
- Radio Front Speaker (2) - Install
- Radio Front Speaker Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
Radio Front Speaker Grille (1) - Install
Instrument Panel Upper Trim Panel (2) - Install
- Instrument Panel Upper Bolt (1) - Install and tighten [ 3x ] - Fastener Specifications
Instrument Panel Fuse Block Access Hole Cover (1) - Install
Instrument Panel Lower Trim Panel Outer Filler (1) - Install
Instrument Panel Instrument Cluster Hood (3) - Install
- Instrument Panel Upper Bolt (2) - Install and tighten [ 4x ] - Fastener Specifications
- Instrument Panel Upper Trim Panel Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
Connect the electrical connector.
- Radio Front Center Speaker (2) - Install
- Radio Front Center Speaker Bolt (1) - Install and tighten [ 2x ] - Fastener Specifications
Connect the electrical connector.
- Instrument Panel Extension (1) - Install
Windshield Garnish Molding Bolt (2) - Install and tighten - Fastener Specifications
- Connect the electrical connector.
- Windshield Garnish Molding (1) - Install
- Enable the SIR System. SIR Disabling and Enabling
NOTE:
Ensure that each tab on the head-up display is properly seated in the mating hole for proper alignment.
CAUTION:
Refer to Fastener Caution .