LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2021 >> Terrain SLT, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Automatic Transmission - 9T45 (M3U) Or 9T50 (M3D M3H) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Lever Replacement

Automatic Transmission Range Selector Lever Cable Lever Replacement

WARNING: This page is about a different car, the 2020 GMC Terrain and 2020 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
GM4677668Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the electronic transmission range selector manual park release cable from the automatic transmission range selector lever cable lever, then position out of the way. Electronic Transmission Range Selector Manual Park Release Cable Replacement (Equinox) , or Electronic Transmission Range Selector Manual Park Release Cable Replacement (Terrain) 
  2. Control Valve Body Replacement 
1 Manual Shaft Detent Lever Hub Pin
CAUTION:

Refer to Fastener Caution .


Procedure 
Install the manual shaft detent lever hub pin to correct height.
NOTE:

Install a NEW manual shaft detent lever hub pin.


Specification 
7.9 mm (0.38 in) (a)
2 Manual Shaft
NOTE:

Lubricate the shaft with ATF to prevent damage to the manual shift shaft seal during installation.

3 Manual Shaft Detent Lever Assembly
4 Park Pawl Actuator